SDNCA4 Laser Dark No Cut Transfer Paper AB set (A4)

SDNCA4 Laser Dark No Cut Transfer Paper AB set (A4)
SDNCA4 Laser Dark No Cut Transfer Paper AB set (A4) SDNCA4 Laser Dark No Cut Transfer Paper AB set (A4) SDNCA4 Laser Dark No Cut Transfer Paper AB set (A4)
Brand: STOLZ
Product SKU: SDNCA4
Availability: 4
Qty:     - OR -   Add to Wish List
Add to Compare

Estimate Shipping Cost

Malaysia Starting from RM9.75

The 2-paper System form STOLZ Premium gives amazaing brilliant colours constant results.

You just print on the transparent A-Foil, press it together with the dark opaque B-Paper and seperate both sheets from each other while hot. Now, you have white coverage on the image through the B-paper.

  • Thickness: 10mic
  • Guide:     Transfer A+B : 165°c, Circle: 70 sec

                           Transfer A to textile : 150°c , Circle: 30sec

  • Works with white toner printer ( recommended brand: OKI)
  • Size: A4 ( A Foil + B Glue Paper 20each)

 

 

Application Instruction

PRINT  TRANSFER B PAPER TO A-FOIL  HEAT PRESS TO GARMENT ➔PEEL PRE PRESS & FINISH

 

 1.PRINT

  • To Print, Use the multi-purpose bypass tray to feed the A-Foil page, printable side face up (the matte side of the A-Foil is printable, do not print on glossy/slick side).  
  • Print your design in Mirror Image Mode onto the Matt Side of the A-Foil.

2.HEAT PRESS

  • Preheat the lower platen of your heat press to 160°C by closing the press while empty for 20-30 seconds - this is only necessary for first presses, or returning to the press after production breaks.
  • Place the A-Foil onto the lower platen (printed side face up). Place the B-Paper (transfer side, with no printed logos, face down) on top of A-Foil sheet. 
  • You may cover with matte finishing paper for additional protection for your heat press platen.

3. TRANSFER B-PAPER TO A-FOIL

  •  Press the A-Foil & B-Paper together at 160°C  for 90 seconds.
  •  Open heat press and  Separate the B-Paper  from the A-Foil without lifting them up from the lower plate of your heat press.
  •  Separate the two sheets immediately, slowly & smoothly. This should leave an opaque white coating onto the toner layer of your printed A-Foil sheet.
  • Trim the edges of the A-Foil sheet to prevent the residual toner on edges from transferring to your garment.

4. APPLICATION TO TEXTILES & OTHER SUBSTRATES

  • Place the textile or another substrate on the lower plate of the heat press
  • Remove from heat press and allow to cool completely before removing the A-Foil backing.
  • Return the garment/substrate to the press and cover the transfer with matte finishing paper and press for 5-10seconds. (It is important to repress the transfer properly to soften the touch and increase the washability)

 

Note:

Textile  Selection
• Always select a less stretchy fabric when working with cotton fabrics (no spandex or lycra).
Reason: This helps to prevent cracking when pulling or stretching the fabric apart

Washing
• Up to 40°C (cold wash cycle). Do not use fabric softener or liquid detergent. Do not tumble dry